• Classic Line

    Classic, reliable, good

CL

Electro-mechanical part-turn actuator

The robust allrounder in classic edition up to 300 Nm

The CL series offers classic drive technology with motor/gear combination and cam mechanism in a classic design. Three series up to 300 Nm in combination with various actuating times open up a wide range of applications for a wide variety of industrial tasks. Of course, the CL series offers not only a robust metal housing, but also all commercially available options, from the additional limit switch to the positioner with load cut-off. Three cable entries M20 x 1.5 allow easy wiring even in the case of high-cross-section leads. The CL series is also available in voltages of 230 V, 115 V, 24 V AC or 24 V DC.

Torque

2...300

Nm

Actuating time

0.6...200

sec/90°

Order right away…

Single component or complete unit.

  • Drive

    CL series

    • Universal, sturdy industrial design

    • Lifetime lubrication

    • Short-circuit proof synchronous motor

    • High self-holding torque

    • Finely adjustable actuating cams

    • Control card PMR, Profi-Bus, CAN-Bus on request

    • Various shaft types and retaining bores available

    • Numerous options as additional switches, potentiometer, position indicator, position controller, load cut-off with fault indicator, gear disengagement, hand wheel etc.

Specifications part-turn actuator CL
CL (S/M/L)
MotorSynchronous motor, short-circuit proof
Torque2…300 Nm
Actuating time0.6…200 s/90°
Travel10°…320° (S and M), optional up to 250 turns
10°…90° (L), optional up to 72 turns
Protection classIP 65 (optional IP 66)
Ambient temperature–15 °C…+60 °C
optional -40 °C…+80 °C
Power supply230 V AC, 50/60 Hz
(optional 24/115 V AC, 400 V DS, 12/24 V DC)
Duty cycle 100%